Barber Colman 16-56 Hobber w/Extended Support

Description

IN STOCK, BUILDABLE TO MEET SPECIFICATIONS

This Barber Colman long bed mechanical gear hobbing machine is a rare commodity because of it very long length of cut. It is suitable for making very long spline shafts or shaft parts with gears or splines at either end or in the center. NOTE- This machine has a desirable extension for the worktable through bore to hold extra long shafts which protrude through the worktable bore.

Features
Air operated tail center
Automatic hob shift
Extended rear overarm with tailstock
Double Thread Index Worm (Standard Accuracy)

Optional Machine Recertification Program
All broken electrical wires and cables will be repaired
All cycles will be tested and verified as fully functional
All defective controls will be replaced or repaired
All defective sensors will be replaced
All features will be tested and verified as fully functional
All filters will be changed
All worn hoses will be replaced
Coolant system checked for problems
Coolant tank and chip collection system cleaned
Hob head will be checked for problems
Hydraulic system drained and cleaned
Machine will be thoroughly cleaned
Ways and gibs checked for problems
Work table drive system checked for problems

The aforementioned description and listing of specifications and accessory equipment is correct and accurate to the best of our knowledge. However, it should not be considered binding in any regard, as we reserve the right to change and/or alter same without prior notice. Consequently the buyer is responsible for confirming same, upon physical inspection and inventory of the machine(s) and all related accessory equipment.